If you’re searching for generator installation near Brighton, CO 80603, something probably got your attention. Maybe the power flickered during a wind event, or a utility crew told you an outage could run for days. We’re based at 625 Baseline Rd in Brighton, so we’ve watched the Front Range grid get tested more than once, and we’ve been out on the calls that follow.
What does a generator installation include?
The generator is only one piece. A complete install usually covers a concrete pad or trailer-mounted setup, the generator itself, an automatic transfer switch (ATS), the fuel supply, electrical wiring, permits, and a startup with a full load test. Each piece has to match the others, which is why we like to look at the whole site before anyone orders equipment.
The ATS is the part that senses when utility power drops and moves your building over to the generator. When a customer calls and says the generator didn’t start, battery trouble is the most common cause, and the ATS comes next. Sometimes the generator is doing its job and the real problem is a tripped breaker downstream. A good install gets all of that set up and tested before you ever need it.
How do you size a generator for a Brighton site?
Sizing is where most installs are won or lost. We start with the one-line diagram, the engineering drawing that ties all of a building’s electrical loads together. It gives us total kW, amperage, and voltage. If you don’t have one handy, even knowing the amperage you need gets us moving.
Then we ask about inrush, which is the surge of amps when motors and compressors start. We also ask about runtime, since that decides how big your fuel tank needs to be, and about future plans. Customers often add equipment a couple of years after install and find the generator is now too small.
Going too big causes its own trouble. A generator that runs at very light load can wet stack, which means unburned fuel leaves through the exhaust and the engine gets carbon buildup. Going too small leads to overload shutdowns and tripped breakers. We aim for the middle.
Altitude matters here too. Brighton sits at roughly 5,000 feet, and engines make less power in thin air. We factor that into the numbers so the unit performs the way the spec sheet says it will on your site.
Our website has a generator sizing tool you can use to get a starting number before you call.
Diesel or natural gas?
Both work well in the Brighton area, and the right pick depends on your site.
Diesel stores on-site, so you don’t depend on a gas line. Diesel gels below 32°F, so cold-weather prep matters. We recommend fuel polishing and winter additives well ahead of the season, and a lot of failure-to-start calls we see come down to an empty tank or old fuel.
Natural gas means no fuel truck and no fuel going stale in a tank. It also takes diesel price swings out of your budget. The tradeoff is that you rely on a gas supply during the event.
How long does it take to get a generator?
Lead times on new generators have stretched because data centers are buying large units in big quantities. On larger sizes, 1500kW and up, new equipment can run 52 weeks or more. If you need power sooner, we stock used generators from 20kW up to 4MW+, and each one goes through a 31-point inspection, oil sampling, a full service, and a load bank test before we sell it. Many used units come from backup applications with only a couple hundred hours on them, so they’re often in very clean shape.
If you have a deadline and nothing in the yard fits yet, a rental can carry you until your permanent unit shows up. Our rental fleet runs from 20kW to 2000kW, typically for two weeks or longer.
Noise, placement, and access
Most sites have a decibel limit, and larger units are louder. We offer enclosures, sound attenuation, and muffler options that can bring the number down. Placement matters for service too. A technician needs room to reach the control panel, the filters, and the radiators, and a spot that’s hard to get to makes every future visit slower.
Who handles the electrical work?
Our field team is made up of certified technicians. For the electrical hookup, we work with licensed electrical contractors and engineering partners, and we coordinate the pieces so you have one point of contact. Permits and inspections vary by city and county, so check with your local building department early, because it shapes your timeline.
What happens after the install?
A generator needs regular care to be ready when you need it. Our preventative maintenance visits include a 31-point inspection, and the checklist is posted on our website if you want to see it. We also recommend a load bank test, which runs the generator up to 80% to 100% of its rated load for one to four hours so any weak spot shows up while you’re still in control of the situation. We suggest replacing batteries every 24 months on emergency units, even when an old one still seems fine.
For facilities backing up life safety equipment, such as hospitals, NFPA 110 requires the generator to pick up the load within 10 seconds. We add those checks into our maintenance work so you stay compliant.
What we can and can’t help with
We sell, rent, service, and buy 60Hz commercial and industrial generators. We don’t sell home standby units under 20kW. If your project is a business, a farm, a job site, a school, a water facility, or a cold storage building, you’re in the right place.
Is a generator worth the cost?
Add up what a day without power would cost you in lost production, spoiled product, and idle employees. For many businesses, one extended outage costs more than the generator. A well-maintained unit also holds its value, so if your needs change down the road, you can sell it and get back a good portion of your investment.
Frequently asked questions
How much does a commercial generator installation cost near Brighton, CO?
Cost depends on generator size, fuel type, the ATS, site work, wiring distance, and permits. Send us an RFQ and we’ll quote the equipment, then work through the install details with you.
How long does installation take?
Equipment availability is the biggest variable. Used inventory and rentals can shorten the wait considerably. Permitting and site work add to the schedule.
Can you install a generator at my house?
We work on commercial and industrial units from 20kW up. We don’t sell or install home standby generators under 20kW.
Do I need an electrician?
Yes. A licensed electrical contractor handles the electrical connection, and we coordinate with them so the job stays on track.
What if my power goes out and I don’t have a generator yet?
Call our Brighton emergency line at 720-990-5106. If we have a rental that fits your load, we’ll work on getting it to you.
Talk to the Brighton team
We’re at 625 Baseline Rd, Brighton, CO 80603, open 7AM to 4PM on weekdays, with on-call technicians covering nights and weekends. If you’re planning an install, start with the sizing tool on our site or send us an RFQ. Tell us about your site and your loads, and we’ll help you find the right fit.